Como usar netstumblerinstaller

Warning: Netinstall will only work on one active interface on your computer, it is highly recommended that you disconnect any other network interfaces in order to be sure that Netinstall will select the right network interface. Note: Netinstall can run also on a local network, in such case you could skip setting a static IP address, but it is highly recommended that you set a static IP address if you are not familiar with Netinstall. Note: It you have a working router, then you can use it and skip the setting up a static IP part of this tutorial, but it requires for you to know your LAN address since you will need to specify an unused IP address in your network for the Network boot server.

For this reason it is recommended to apply a static IP address and follow this guide precisely, if you are not sure how to get these parameters out of your network. Note: If you followed the guide precisely, then you should not have any Internet connection on your computer, Windows 10 wants to verify all apps that it runs, but will not be able to do it since lack of the Internet connection, for this reason a warning might pop up, you should click Run.

Warning: Netinstall requires administrator rights, there should be a window asking for permissions to run Netinstall, you must accept these permissions in order for Netinstall to work properly.

Warning: The Client IP address must be unique! Don't use an existing IP address in your network, this also means that you should not use the computer's IP address as well. Use a completely different IP address from the same subnet.

Warning: Some computer's have a network interface especially USB Ethernet adapters that tend to create an extra link flap, which is enough for Netinstall to fail to detect a device that is in Etherboot mode. In such case you can use a switch between your device and your computer or a router in bridge mode to prevent this issue. Note: There are multiple ways how to put your device into Etherboot mode. Make sure you read the Etherboot manual before trying to put the device into this mode.

Methods vary between different MikroTik devices. Note: If the device does not show up in this window, then you can try closing the Netinstall application and opening it up again or try to put the device into Etherboot mode again.

Note: If you downloaded RouterOS packages for multiple architectures, then Netinstall will only show the appropriate architecture packages for your device after you have selected it. All unsupported packages will not show up in this window after you have selected a device. Debes seguir esta guia. Este sitio usa Akismet para reducir el spam. Este sitio web utiliza cookies para que usted tenga la mejor experiencia de usuario.

Andando: 1,50 segundos. Corriendo, footing…: 1,25 segundos. Yo particularmente prefiero tenerlo desactivado para poder conectarme con la utilidad de Windows y usar el Netstumbler al mismo tiempo. Por mi experiencia puedo decir que solo muestra la IP cuando estas conectado a la red. Quedan pendientes para otro manual. Si tenemos varias tarjetas podemos abrir varios Netstumblers al mismo tiempo y en cada uno seleccionar una tarjeta diferente para comparar.

Hay varios programas que permiten posicionar las capturas de Netstumbler que hemos realizado con un GPS en un mapa. Los mas utilizados son:. Stumbverter 1. Saltar al contenido.